E. Guelpa and V. Verda, Optimization of the Thermal Load Profile in District Heating Networks through "Virtual Storage, at Building Level. Energy Procedia, vol.101, pp.798-805, 2016.

J. Kensby, A. Trüschel, and J. Dalenbäck, Potential of residential buildings as thermal energy storage in district heating systems -Results from a pilot test, Appl Energy, vol.137, pp.773-81, 2015.

M. Le?ko and W. Bujalski, Operational optimization in district heating systems using thermal inertia of buildings, Rynek Energii, 2016.

G. Reynders, A. Lopes, R. Marszal-pomianowska, A. Aelenei, D. Martins et al., Energy flexible buildings: An evaluation of definitions and quantification methodologies applied to thermal storage, Energy Build, vol.166, pp.372-90, 2018.

K. Foteinaki, R. Li, A. Heller, and C. Rode, Heating system energy flexibility of low-energy residential buildings, Energy Build, vol.180, pp.95-108, 2018.

A. Rabl and A. Rialhe, Energy signature models for commercial buildings: test with measured data and interpretation, Energy Build, vol.19, pp.143-54, 1992.

K. A. Antonopoulos and E. P. Koronaki, Effect of indoor mass on the time constant and thermal delay of buildings, Int J Energy Res, vol.24, pp.391-402, 2000.

, 114X, vol.24, 200004.

H. Johra, P. Heiselberg, and J. L. Dréau, Influence of envelope, structural thermal mass and indoor content on the building heating energy flexibility, Energy Build, vol.183, pp.325-364, 2019.
URL : https://hal.archives-ouvertes.fr/hal-01938171

L. Dréau, J. Heiselberg, and P. , Energy flexibility of residential buildings using short term heat storage in the thermal mass, Energy, vol.111, pp.991-1002, 2016.

K. J. Kircher, M. Zhang, and K. , On the lumped capacitance approximation accuracy in RC network building models, Energy Build, vol.108, pp.454-62, 2015.

J. Rubio-herrero, V. Chandan, C. Siegel, A. Vishnu, and D. Vrabie, A Learning Framework for Control-Oriented Modeling of Buildings, IEEE Int. Conf. Mach. Learn. Appl. ICMLA, pp.473-481, 2017.

T. Berthou, P. Stabat, R. Salvazet, and D. Marchio, Development and validation of a gray box model to predict thermal behavior of occupied office buildings, Energy Build, vol.74, pp.91-100, 2014.
URL : https://hal.archives-ouvertes.fr/hal-01299414

G. Fraisse, C. Viardot, O. Lafabrie, and G. Achard, Development of a simplified and accurate building model based on electrical analogy, 2002.

H. Harb, N. Boyanov, L. Hernandez, R. Streblow, and D. Müller, Development and validation of grey-box models for forecasting the thermal response of occupied buildings, Energy Build, vol.117, pp.199-207, 2016.

J. Vivian, A. Zarrella, G. Emmi, D. Carli, and M. , An evaluation of the suitability of lumpedcapacitance models in calculating energy needs and thermal behaviour of buildings, Energy Build, vol.150, pp.447-65, 2017.

G. Reynders, J. Diriken, and D. Saelens, Quality of grey-box models and identified parameters as function of the accuracy of input and observation signals, Energy Build, vol.82, pp.263-74, 2014.

N. Aoun, R. Bavière, M. Vallée, A. Brun, and G. Sandou, Dynamic simulation of residential buildings supporting the development of flexible control in district heating systems, 13th Int. Model. Conf, 2019.
URL : https://hal.archives-ouvertes.fr/hal-02068479

E. T. Ademe and . France, , 2015.

H. Johra and P. Heiselberg, Influence of internal thermal mass on the indoor thermal dynamics and integration of phase change materials in furniture for building energy storage: A review, Renew Sustain Energy Rev, vol.69, pp.19-32, 2017.

A. Auliciems and S. V. Szokolay, Department of Achitecture. Thermal comfort. Brisbane: PLEA, 1997.

H. Wolisz, P. Block, R. Streblow, and D. Müller, Dynamic activation of structural thermal mass in a multi-zonal building with due regard to thermal comfort. 14th Int, Conf. Int. Build. Perform. Simul. Assoc. Hyderabad India, 2015.

D. Olsthoorn, F. Haghighat, A. Moreau, and G. Lacroix, Abilities and limitations of thermal mass activation for thermal comfort, peak shifting and shaving: A review, Build Environ, vol.118, pp.113-140, 2017.

M. Wetter, Generic Optimization Program, User Manual, Version 3.1.1. Lawrence Berkeley National Laboratory, 2016.